Print failure - became spongy and stringy mid-print – How do I

I was printing a 73mm high model yesterday. The first 25mm went fine, but then the print became "spongy" and "stringy" as if not enough filament was b

3D Printer Issues and How to Troubleshoot them

Failed 3D Prints, and How to Fix Them : 6 Steps (with Pictures) - Instructables

OVERTURE TPU Filament 1.75mm Flexible TPU Roll, 95A Soft 3D Printer Filament, 1kg Spool (2.2 lbs), Dimensional Accuracy +/- 0.02 mm (TPU Black) : Industrial & Scientific

3D Printer Printing Too Thin – Let's Fix It! –

Printing Guidance】The Influence of Filament Dryness and Humidity on Printing Effect

3D Printing Troubleshooting: All Problems & Solutions

Failed 3D Prints, and How to Fix Them : 6 Steps (with Pictures) - Instructables

3D Printing Troubleshooting: All Problems & Solutions

Resin 3D Printing Troubleshooting: A Comprehensive Guide

3D Printing Troubleshooting: All Problems & Solutions

First Prints With Stringy Edges / Messy First Layers – Assembly and first prints troubleshooting – Prusa3D Forum

3D Printing Troubleshooting: All Problems & Solutions